Home › BODY ELECTRICAL › DOOR LOCK › FRONT DOOR LOCK (for Double Cab)

FRONT DOOR LOCK (for Double Cab) > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR LOCK ASSEMBLY LH


  1. Check the door lock motor.



      B167563E01
    1. Apply battery voltage to the door lock motor and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Lock
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.

  1. Check the door lock position switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (LSSE) - 8 (E)
      Unlock
      Below 1 Ω
      Lock
      10 kΩ or higher

      1. If the result is not as specified, replace the door lock assembly.



  1. Check the door lock and unlock switch.



      B167564E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      9 (DLSR) - 7 (LSSR)
      Lock
      Below 1 Ω
      10 (E) - 7 (LSSR)
      Unlock
      9 (DLSR) - 7 (LSSR)
      Unlock
      10 kΩ or higher
      10 (E) - 7 (LSSR)
      Lock

      1. If the result is not as specified, replace the door lock assembly.



2. INSPECT FRONT DOOR LOCK ASSEMBLY RH


  1. Check the door lock motor.



      B167565E01
    1. Apply battery voltage to the door lock motor and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Lock
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.

  1. Check the door lock position switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (LSSR) - 8 (E)
      Unlock
      Below 1 Ω
      Lock
      10 kΩ or higher

      1. If the result is not as specified, replace the door lock assembly.