Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream main switch ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

  1. Read the value displayed on the tester.

    Accel Sensor Out No. 1 standard voltage:
    Condition
    Specified Condition
    Accelerator pedal is released
    0.5 to 1.1 V
    Accelerator pedal is depressed
    2.6 to 4.5 V

    Accel Sensor Out No. 2 standard voltage:
    Condition
    Specified Condition
    Accelerator pedal is released
    1.2 to 2.0 V
    Accelerator pedal is depressed
    3.4 to 5.0 V

    If the result is not as specified, check the accelerator pedal, wire harness or ECM.