CIRCUIT OPENING RELAY > ON-VEHICLE INSPECTION |
| 1. REMOVE CIRCUIT OPENING RELAY (C/OPN) |
Remove the circuit opening relay from the engine room relay block.
| 2. INSPECT CIRCUIT OPENING RELAY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When no battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 3. INSTALL CIRCUIT OPENING RELAY |