Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY



B166134E06

  1. for Regular Cab:

    1. Remove the master switch (Click here).

    2. Reconnect the switch connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      for Driver Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-10 (U) - N2-7 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-12 (D) - N2-7 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → DOWN
      N2-12 (D) - N2-7 (E)
      Ignition switch ON, driver side door glass fully closed → power window AUTO DOWN operation → driver side door glass fully open
      Below 1 V → 11 to 14 V → Below 1 V
      for Front Passenger Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-16 (U) - N2-7 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-18 (D) - N2-7 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → DOWN

  1. for Double Cab:

    1. Remove the power window regulator master switch (Click here).

    2. Reconnect the switch connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      for Driver Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-3 (U) - N2-1 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-4 (D) - N2-1 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → DOWN
      N2-4 (D) - N2-1 (E)
      Ignition switch ON, driver side door glass fully closed → power window AUTO DOWN operation → driver side door glass fully open
      Below 1 V → 11 to 14 V → Below 1 V
      for Front Passenger Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-16 (U) - N2-1 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-15 (D) - N2-1 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → DOWN
      for Rear Switch LH: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-12 (U) - N2-1 (E)
      Ignition switch ON, rear LH side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-13 (D) - N2-1 (E)
      Ignition switch ON, rear LH side door power window regulator switch OFF → DOWN
      for Rear Switch RH: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-10 (U) - N2-1 (E)
      Ignition switch ON, rear RH side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-18 (D) - N2-1 (E)
      Ignition switch ON, rear RH side door power window regulator switch OFF → DOWN

  1. for CrewMax:

    1. Remove the power window regulator master switch (Click here).

    2. Reconnect the switch connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      for Driver Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-3 (U) - N2-1 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-4 (D) - N2-1 (E)
      Ignition switch ON, driver side door power window regulator switch OFF → DOWN
      N2-4 (D) - N2-1 (E)
      Ignition switch ON, driver side door glass fully closed → power window AUTO DOWN operation → driver side door glass fully open
      Below 1 V → 11 to 14 V → Below 1 V
      for Front Passenger Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-16 (U) - N2-1 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-15 (D) - N2-1 (E)
      Ignition switch ON, front passenger side door power window regulator switch OFF → DOWN
      for Rear LH Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-12 (U) - N2-1 (E)
      Ignition switch ON, rear LH side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-13 (D) - N2-1 (E)
      Ignition switch ON, rear LH side door power window regulator switch OFF → DOWN
      for Rear RH Switch: 
      Tester Connection
      Switch Condition
      Specified Condition
      N2-10 (U) - N2-1 (E)
      Ignition switch ON, rear RH side door power window regulator switch OFF → UP
      Below 1 V → 11 to 14 V
      N2-18 (D) - N2-1 (E)
      Ignition switch ON, rear RH side door power window regulator switch OFF → DOWN