Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR


A159234E04
  1. Disconnect the 2 sensor connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (for Bank 1 sensor 2):
    Tester Connection
    Condition
    Specified Condition
    1 (HT1B) - 2 (+B)
    20°C (68°F)
    11 to 16 Ω

    Standard resistance (for Bank 2 sensor 2):
    Tester Connection
    Condition
    Specified Condition
    1 (HT2B) - 2 (+B)
    20°C (68°F)
    11 to 16 Ω

    If the result is not as specified, replace the sensor.

  1. Connect the 2 sensor connectors.