Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2325    LIN Communication Bus Malfunction

for Preparation Click here


DESCRIPTION

The main body ECU intermittently monitors the LIN communication bus between the components related to the door and sliding roof. DTC B2325 is output when a malfunction in the LIN communication bus between the components related to sliding roof is detected consecutively 3 times.

DTC Code
DTC Detection Condition
Trouble Area
B2325
Main body ECU detects malfunction of LIN communication bus between components related to sliding roof consecutively 3 times
  1. Sliding roof drive gear sub-assembly
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


B171975E01


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

HINT:
When DTC B2325 and a LIN communication stop DTC are output simultaneously, first perform the troubleshooting for the LIN communication stop DTC. Then perform the troubleshooting for DTC B2325.

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).
    Result: 
    Result
    Proceed to
    DTC B2325 output reoccurs
    A
    DTC B1273 output reoccurs
    B
    DTC output does not reoccur
    C



B
GO TO DTC B1273 (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF DRIVE GEAR)

B171976E01

  1. Disconnect the J2 ECU connector.

  1. Disconnect the W3 gear connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J2-10 (LIN2) - W3-3 (SPD)
    Always
    Below 1 Ω
    J2-10 (LIN2) or W3-3 (SPD) - Body ground
    Always
    10 kΩ or higher

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J2-10 (LIN2) or W3-3 (SPD) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Clear the DTC (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTC (Click here).
    Result: 
    Result
    Proceed to
    DTC B2325 output does not reoccur
    A
    DTC B2325 output reoccurs
    B



B
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (Click here)
A

END