Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


2. REMOVE FOG LIGHT ASSEMBLY LH


    E144974E01
  1. for Steel Type Bumper:

    1. Disconnect the connector.

    2. Push the tabs on the grommet.

    3. Detach the 2 claws and remove the fog light.



    E144957E01
  1. for Resin Type Bumper:

    1. Disconnect the connector.

    2. Push the tabs on the aiming screw.

    3. Detach the 2 claws and remove the fog light.