Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SWITCH


    E143366E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Hazard warning switch OFF
    10 kΩ or higher
    Hazard warning switch ON
    Below 1 Ω

    If the result is not as specified, replace the warning switch.

  1. Connect the battery's positive (+) lead to terminal 3 and the negative (-) lead to terminal 2.

  1. Check that the light comes on.

    OK:
    Light comes on

    If the result is not as specified, replace the warning switch.