Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


    E142788
  1. Attach the 2 claws to install the adjuster.



2. INSTALL STOP LIGHT SWITCH ASSEMBLY


    E145371E01
  1. Insert the stop light switch so that it contacts the pedal cushion.

    NOTICE:
    insert the stop light switch with a force of less than 98 N*m (1000 kgf*cm 72.3 ft.*lbf).



    E146102E01
  1. Rotate the stop light switch clockwise 90° to install it to the adjuster.

    Standard:
    A: 1.5 to 2.5 mm (0.0591 to 0.0984 in.)

    NOTICE:
    1. When the stop light switch is rotated clockwise, make sure the stop light switch moves outward less than 1 pitch (pitch: distance between 2 screw threads).
    2. Rotate the stop light switch with a torque of 1.5 N*m (15 kgf*cm.13 in.*lbf).
    3. Do not allow silicon grease to contact the stop light switch.



    E145370
  1. Connect the connector.