Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)

E146648E01

  1. Disconnect the J3, J4, DB, DC and DD ECU connectors.



  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J4-9 (LSWD) - Body ground
    P - Body ground
    Front door unlock detection switch LH input
    Front door LH UNLOCK
    Below 1 V
    Front door LH LOCK
    11 to 14 V (or pulse generation [see waveform 1 or 2])
    J3-27 (LSWP) - Body ground
    V - Body ground
    Front door unlock detection switch RH input
    Front door RH UNLOCK
    Below 1 V
    Front door RH LOCK
    11 to 14 V (or pulse generation [see waveform 3 or 4])
    DC-1 (LSWL) - Body ground
    GR - Body ground
    Rear door unlock detection switch LH input
    Rear door LH UNLOCK
    Below 1 V
    Rear door LH LOCK
    11 to 14 V (or pulse generation [see waveform 5 or 6])
    J3-5 (LSWR) - Body ground
    Y - Body ground
    Rear door unlock detection switch RH input
    Rear door RH UNLOCK
    Below 1 V
    Rear door RH LOCK
    11 to 14 V (or pulse generation [see waveform 7 or 8])
    DD-3 (ACT+) - Body ground
    W - Body ground
    Door lock motor LOCK drive output
    Door control switch or front door key cylinder LH OFF
    Below 1 V
    Door control switch or front door key cylinder LH LOCK
    11 to 14 V
    J4-5 (ACTD) - Body ground
    P - Body ground
    Door lock motor UNLOCK drive output
    Door control switch or front door key cylinder LH UNLOCK
    11 to 14 V
    Door control switch or front door key cylinder LH OFF
    Below 1 V
    DD-2 (ACT-) - Body ground
    L - Body ground
    Door lock motor UNLOCK drive output
    Door control switch or front door key cylinder LH UNLOCK
    11 to 14 V
    Door control switch or front door key cylinder LH OFF
    Below 1 V
    DC-24 (ACT+) - Body ground
    W - Body ground
    Door lock motor LOCK drive output
    Door control switch or front door key cylinder LH OFF
    Below 1 V
    Door control switch or front door key cylinder LH LOCK
    11 to 14 V
    DC-23 (ACT-) - Body ground
    L - Body ground
    Door lock motor UNLOCK drive output
    Door control switch or front door key cylinder LH UNLOCK
    11 to 14 V
    Door control switch or front door key cylinder LH OFF
    Below 1 V
    DD-53 (L2) - Body ground
    V - Body ground
    Front door key switch LH LOCK input
    Front door key cylinder LH LOCK
    Below 1 V
    Ignition switch OFF, all doors closed and front door key cylinder LH neutral position
    11 to 14 V (or pulse generation [see waveform 9 or 10])
    J4-10 (UL3) - Body ground
    B - Body ground
    Front door key switch LH UNLOCK input
    Front door key cylinder LH UNLOCK
    Below 1 V
    Ignition switch OFF, all doors closed and front door key cylinder LH neutral position
    11 to 14 V (or pulse generation [see waveform 9 or 10])
    DD-49 (L1) - Body ground
    W - Body ground
    Door control switch LOCK input
    Door control switch OFF
    10 kΩ or higher
    Door control switch LOCK
    Below 1 Ω
    DD-52 (UL1) - Body ground
    R - Body ground
    Front door control switch LH UNLOCK input
    Front door control switch LH OFF
    10 kΩ or higher
    Front door control switch LH UNLOCK
    Below 1 Ω
    DD-40 (UL1) - Body ground
    W - Body ground
    Front door control switch RH UNLOCK input
    Front door control switch RH OFF
    10 kΩ or higher
    Front door control switch RH UNLOCK
    Below 1 Ω
    DD-62 (GND1,GND2) - Body ground
    W-B - Body ground
    Power ground
    Always
    Below 1 Ω
    DB-13 (BECU) - Body ground
    GR - Body ground
    +B power source (signal system)
    Always
    11 to 14 V
    If the result is not as specified, the ECU may have a malfunction.



      B152510E01
    1. Using an oscilloscope, check the waveform 1.
      Waveform 1 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      J4-9 (LSWD) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Front door LH LOCK



    2. B152509E01
    3. Using an oscilloscope, check the waveform 2.
      Item
      Content
      Terminal No. (Symbols)
      J4-9 (LSWD) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Front door LH LOCK



    4. B152510E01
    5. Using an oscilloscope, check the waveform 3.
      Waveform 3 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      J3-27 (LSWP) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Front door RH LOCK



    6. B152509E01
    7. Using an oscilloscope, check the waveform 4.
      Waveform 4 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      J3-27 (LSWP) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Front door RH LOCK



    8. B152510E01
    9. Using an oscilloscope, check the waveform 5.
      Waveform 5 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      DC-1 (LSWL) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Rear door LH LOCK



    10. B152509E01
    11. Using an oscilloscope, check the waveform 6.
      Waveform 6 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      DC-1 (LSWL) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Rear door LH LOCK



    12. B152510E01
    13. Using an oscilloscope, check the waveform 7.
      Waveform 7 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      J3-5 (LSWR) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Rear door RH LOCK



    14. B152509E01
    15. Using an oscilloscope, check the waveform 8.
      Waveform 8 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      J3-5 (LSWR) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Rear door RH LOCK



    16. B152510E01
    17. Using an oscilloscope, check the waveform 9.
      Waveform 9 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      DD-53 (L2) - Body ground
      J4-10 (UL3) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Ignition switch OFF, all doors closed and front door lock key cylinder LH neutral position



    18. B152509E01
    19. Using an oscilloscope, check the waveform 10.
      Waveform 10 (Reference) 
      Item
      Content
      Terminal No. (Symbols)
      DD-53 (L2) - Body ground
      J4-10 (UL3) - Body ground
      Tool Setting
      5 V/DIV., 20 ms/DIV.
      Condition
      Ignition switch OFF, all doors closed and front door lock key cylinder LH neutral position