POWER DOOR LOCK CONTROL SYSTEM > Driver Side Door UNLOCK Detection Switch Circuit |

| 1.READ VALUE USING TECHSTREAM (UNLOCK DETECTION SWITCH) |
Check the Data List to ensure proper functioning of the unlock detection switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D-Door Lock Pos SW | Driver side door unlock detection switch signal / ON or OFF | ON: Driver side door is unlocked OFF: Driver side door is locked | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY LH (UNLOCK DETECTION SWITCH) |
![]() |
Remove the front door lock motor LH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (LSSR) - 7 (E) | Lock | 10 kΩ or higher |
| Unlock | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR LH - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the N4 door lock connector.
Disconnect the J4 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N4-8 (LSSR) - J4-9 (LSWD) | Always | Below 1 Ω |
| N4-8 (LSSR) - Body ground | Always | 10 kΩ or higher |
| N4-7 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||