Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Front Passenger Side Door UNLOCK Detection Switch Circuit

for Preparation Click here


DESCRIPTION

The front passenger side door unlock detection switch is built into the front passenger door lock motor. The switch turns on when the front passenger door is unlocked and turns off when the door is locked. The main body ECU is connected to the front passenger door lock motor via terminal LSWP and front passenger door lock/unlock state signals are input to the ECU. The main body ECU applies voltage to the door unlock detection switch via terminal LSWP. When the door unlock detection switch is off (there is continuity between the switch terminals), a lock state signal is input to the ECU. When the switch is on (there is no continuity between the switch terminals), an unlock state signal is input.

WIRING DIAGRAM


E144706E03


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (UNLOCK DETECTION SWITCH)
  1. Check the Data List to ensure proper functioning of the unlock detection switch.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P-Door Lock Pos SW
    Front passenger side door unlock detection switch signal / ON or OFF
    ON: Front passenger side door is unlocked
    OFF: Front passenger side door is locked
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY RH (UNLOCK DETECTION SWITCH)
E147087E01
  1. Remove the front door lock motor RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (LSSR) - 8 (E)
    Lock
    10 kΩ or higher
    Unlock
    Below 1 Ω



NG
REPLACE FRONT DOOR LOCK MOTOR ASSEMBLY RH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR RH - MAIN BODY ECU AND BODY GROUND)
E144689E01
  1. Disconnect the M4 door lock connector.

  1. Disconnect the J3 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    M4-7 (LSSR) - J3-27 (LSWP)
    Always
    Below 1 Ω
    M4-7 (LSSR) - Body ground
    Always
    10 kΩ or higher
    M4-8 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU