Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Driver Side Door Lock Motor Circuit

for Preparation Click here


DESCRIPTION

The main body ECU controls the front door lock motor LH to lock/unlock the front door LH. This ECU applies current from terminal ACT+ to terminal ACTD to operate the motor to lock the door. It reverses the direction of the current flow to operate the motor to unlock the door.

WIRING DIAGRAM


E144949E02


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY LH
E147083E02
  1. Remove the front door lock motor LH (Click here).

  1. Apply battery voltage and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4 (L)
    Battery negative (-) → Terminal 1 (UL)
    Lock
    Battery positive (+) → Terminal 1 (UL)
    Battery negative (-) → Terminal 4 (L)
    Unlock



NG
REPLACE FRONT DOOR LOCK MOTOR ASSEMBLY LH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR LH - MAIN BODY ECU)

E177923E01

  1. Disconnect the N4 door lock connector.

  1. Disconnect the DD and J4 ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N4-4 (L) - DD-3 (ACT+)
    Always
    Below 1 Ω
    N4-1 (UL) - J4-5 (ACTD)
    DD-3 (ACT+) - Body ground
    Always
    10 kΩ or higher
    J4-5 (ACTD) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU