POWER DOOR LOCK CONTROL SYSTEM > Front Passenger Side Door Lock Motor Circuit |

| 1.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY RH |
![]() |
Remove the front door lock motor RH (Click here).
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Lock |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlock |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR RH - MAIN BODY ECU) |

Disconnect the M4 door lock connector.
Disconnect the DD ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M4-4 (L) - DD-3 (ACT+) | Always | Below 1 Ω |
| M4-1 (UL) - DD-2 (ACT-) | ||
| DD-3 (ACT+) - Body ground | Always | 10 kΩ or higher |
| DD-2 (ACT-) - Body ground |
|
| ||||
| OK | ||
| ||