DTC U0199 Lost Communication with "Door Control Module A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0199 | No communication from outer mirror control ECU |
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (OUTER MIRROR CONTROL ECU BRANCH WIRE) |
![]() |
Disconnect the N8 outer mirror control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N8-1 (CAN) - N8-21 (CGND) | Ignition switch OFF | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU - BATTERY AND BODY GROUND) |
Reconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
![]() |
Disconnect the N7 outer mirror control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N7-9 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N7-3 (B) - Body ground | Always | 11 to 14 V |
| N7-4 (ACC) - Body ground | Ignition switch ACC |
|
| ||||
| OK | ||
| ||