Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

DTC    U0208    Lost Communication with "Seat Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0208
No communication from front power seat control ECU with switch LH
  1. Power source circuit of front power seat control ECU and switch LH
  2. Front power seat control ECU and switch LH
  3. Front power seat control ECU and switch LH branch wire or connector

WIRING DIAGRAM


C158945E01


INSPECTION PROCEDURE

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTICE:
    After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT CONTROL ECU AND SWITCH LH BRANCH WIRE)


    C159483E01
  1. Disconnect the Z10 front power seat control ECU and switch LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Z10-5 (CANH) - Z10-1 (CANL)
    Ignition switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE FRONT POWER SEAT CONTROL ECU AND SWITCH LH BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT CONTROL ECU AND SWITCH LH - BATTERY AND BODY GROUND)
  1. Reconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.



    C159482E01
  1. Disconnect the Z9 and Z10 front power seat control ECU and switch LH connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Z9-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Z9-5 (+B) - Body ground
    Always
    11 to 14 V
    Z10-8 (SYSB) - Body ground
    Z10-4 (IG) - Body ground
    Ignition switch ON



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY (Click here)