DTC B1442/42 Air Inlet Damper Control Servo Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1442/42 | Air inlet damper position sensor value does not change even if air conditioning amplifier operated air inlet damper servo motor |
|

| 1.READ VALUE USING TECHSTREAM (AIR INLET DAMPER TARGET PULSE) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Air Inlet Damper Targ Pulse | Air inlet damper target pulse / Min.: 7 Max.: 28 | REC: 7 FRS: 28 | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR INLET SERVO MOTOR |
Temporarily replace the air inlet servo motor with a new one (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPAIR OR REPLACE AIR CONDITIONING HARNESS |
Repair or replace the air conditioning harness.
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC again (Click here).
|
| ||||
| OK | ||
| ||