DTC B1443/43 Air Outlet Damper Control Servo Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1443/43 | Air outlet damper position sensor value does not change even if air conditioning amplifier operates air outlet servo motor |
|

| 1.READ VALUE USING TECHSTREAM (AIR OUTLET SERVO MOTOR TARGET PULSE) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Air Outlet Servo Pulse (D) | Air outlet servo motor target pulse / Min.: 9 Max.: 97 | FACE: 9 (pulse) MID: 25 (pulse) B/L: 32 (pulse) MID: 39 (pulse) FOOT: 56 (pulse) MID: 77 (pulse) FOOT/DEF: 83 (pulse) MID: 91 (pulse) DEF: 97 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR OUTLET SERVO MOTOR |
Temporarily replace the air outlet servo motor with a new one (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPAIR OR REPLACE AIR CONDITIONING HARNESS |
Repair or replace the air conditioning harness.
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC again (Click here).
|
| ||||
| OK | ||
| ||