AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > ECU Power Source Circuit |

| 1.INSPECT FUSE (A/C) |
Remove the A/C fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A/C fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J19 air conditioning amplifier connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J19-14 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| J19-21 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||