SEAT HEATER SWITCH (for Floor Shift Type) > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
for Double Cab:
Remove the front door scuff plate .
for Regular Cab:
Remove the front door scuff plate .
| 2. REMOVE COWL SIDE TRIM BOARD LH |
for Double Cab:
Remove the cowl side trim board .
for Regular Cab:
Remove the cowl side trim board .
| 3. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 4 clips and claw.
![]() |
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Disconnect the connector and clamp.
Detach the 12 clips and remove the finish panel.
| 6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
Remove the clip.
Detach the 6 clips and remove the console panel.
w/Trailer Towing System:
Disconnect the connector

| 8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the console panel.
| 9. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Detach the 4 clips.
Remove the finish panel and then disconnect the connectors.
| 10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Detach the 4 clips.
Disconnect the integration control and panel connectors and remove the panel.
| 11. REMOVE SEAT HEATER SWITCH LH |
![]() |
Detach the 2 claws and remove the seat heater switch.
| 12. REMOVE SEAT HEATER SWITCH RH |
![]() |
Detach the 2 claws and remove the seat heater switch.