Home › BODY › EXTERIOR › FRONT BUMPER (for Steel Type Bumper)

FRONT BUMPER (for Steel Type Bumper) > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146465E01
  1. Align the keyhole and protrusion as shown in the illustration.

  1. Install the sensor retainer to the front bumper.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the retainer.



2. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146466
  1. Attach the 2 claws to install the ultrasonic sensor.



3. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)


B165512
  1. Attach the 3 claws to install the hole cover.



4. INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedures described for the LH side.



5. INSTALL FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light)


B165511
  1. Attach the 3 claws to install the bracket.



6. INSTALL FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



7. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)


E144974
  1. Attach the 2 claws to install the fog light.



8. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



9. INSTALL FRONT VALANCE PANEL


  1. Install the panel with the 10 bolts and 2 nuts.

    Torque:
    for bolt:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
    for nut:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B165510



10. INSTALL FRONT LOWER BUMPER RETAINER SUB-ASSEMBLY


  1. Install the retainer with the 10 clips.


    B165509