FRONT BUMPER (for Resin Type Bumper) > DISASSEMBLY |
| 1. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light) |
![]() |
Remove the 2 screws.
Detach the 3 claws and remove the hole cover.
| 2. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light) |
| 3. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light) |
![]() |
Detach the 2 claws and remove the fog light.
| 4. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light) |
| 5. REMOVE FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light) |
![]() |
Remove the 2 screws.
Detach the 3 claws and remove the bracket.
| 6. REMOVE FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light) |
| 7. REMOVE FRONT VALANCE PANEL |
Remove the 10 bolts, 2 nuts and panel.

| 8. REMOVE FRONT FENDER LINER BRACKET LH |
![]() |
Detach the 2 claws and remove the bracket.
| 9. REMOVE FRONT FENDER LINER BRACKET RH |
| 10. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) |
![]() |
While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.
| 11. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) |
![]() |
Detach the 2 claws and remove the sensor retainer from the front bumper.