Home › BODY › EXTERIOR › FRONT BUMPER (for Resin Type Bumper)

FRONT BUMPER (for Resin Type Bumper) > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146465E01
  1. Align the keyhole and protrusion as shown in the illustration.

  1. Install the sensor retainer to the front bumper.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the retainer.



2. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146466
  1. Attach the 2 claws to install the ultrasonic sensor.



3. INSTALL FRONT FENDER LINER BRACKET LH


B165633
  1. Attach the 2 claws to install the bracket.



4. INSTALL FRONT FENDER LINER BRACKET RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL FRONT VALANCE PANEL


  1. Install the panel with the 10 bolts and 2 nuts.

    Torque:
    for bolt:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
    for nut:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B165632E01



6. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)


B165634
  1. Attach the 3 claws to install the hole cover.

  1. Install the 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedures described for the LH side.



8. INSTALL FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light)


B165635
  1. Attach the 3 claws to install the bracket.

  1. Install the 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



9. INSTALL FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



10. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)


E144957
  1. Attach the 2 claws to install the fog light.



11. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.