Home › BODY › EXTERIOR › REAR BUMPER (for Steel Type Bumper)

REAR BUMPER (for Steel Type Bumper) > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146470
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



2. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146469
  1. Detach the 2 claws and remove the sensor retainer from the rear bumper.



3. REMOVE NO. 2 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146468
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



4. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146469
  1. Detach the 2 claws and remove the sensor retainer from the rear bumper.