Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for CrewMax)

FRONT DOOR BELT MOULDING (for CrewMax) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT UPPER ARMREST BASE PANEL LH


    B166211
  1. Using a screwdriver, detach the 2 clips and front armrest upper base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E02
  1. Detach the 3 clips and remove the front lower door frame bracket garnish.



4. REMOVE COURTESY LIGHT ASSEMBLY


    B165655
  1. Detach the claw and remove the courtesy light from the door trim board.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR ARMREST COVER LH


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B166215E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


B166364E02
  1. w/ Power Mirror Control System:
    Disconnect the connector labeled A.

  1. Remove the 3 nuts and claw.

  1. Remove the outer rear view mirror.



8. REMOVE FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH


B165859E02
  1. Put protective tape around the weatherstrip outer.

  1. Using a moulding remover, detach the claw and remove the weatherstrip.