Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING (for CrewMax)

REAR DOOR BELT MOULDING (for CrewMax) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR OUTER DOOR GLASS WEATHERSTRIP LH


B169237
  1. Attach the claw to install the weatherstrip.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.



    B169254E01
  1. Attach the inside handle's knob to the door trim board.

  1. for 12 Speakers:

    1. Connect the connector.

  1. Attach the 10 clips to install the door trim board.

  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Install the clip.



3. INSTALL REAR DOOR ARMREST COVER LH


4. INSTALL COURTESY LIGHT ASSEMBLY


    B165683
  1. Connect the connector.

  1. Attach the claw to install the courtesy light.



5. INSTALL REAR DOOR FRAME GARNISH LH


    B169253
  1. Attach the 5 clips to install the rear door frame garnish.



6. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH


    B168094
  1. Connect the connector.

  1. Attach the 2 clips to install the rear door armrest upper base panel.



7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B168093
  1. Attach the 4 claws to install the bezel plug.