REAR DOOR BELT MOULDING (for Double Cab) > REMOVAL |
| 1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH |
![]() |
Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.
| 3. REMOVE REAR DOOR FRAME GARNISH LH |
![]() |
Detach the 4 clips and remove the rear door frame garnish.
| 4. REMOVE COURTESY LIGHT ASSEMBLY |
![]() |
Detach the claw and remove the courtesy light from the door trim.
Disconnect the connector.
| 5. REMOVE REAR DOOR ARMREST COVER LH |
| 6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
Detach the 9 clips and remove the trim cover. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
| 7. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP LH |
![]() |
Put protective tape around the weatherstrip outer.
Using a moulding remover, detach the claw and remove the weatherstrip.