ROOF DRIP SIDE FINISH MOULDING > REMOVAL |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Moulding | 20 to 30°C (68 to 86°F) |
| Clip | 20 to 30°C (68 to 86°F) |
| 1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH |
![]() |
Put protective tape around the moulding.
Using a heat light, heat the moulding.
Using a moulding remover, detach the clip and remove the moulding.
| 2. REMOVE ROOF DRIP SIDE FINISH MOULDING LH |
Put protective tape around the moulding.
Using a moulding remover, detach the clip and remove the moulding.

| 3. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP |
Remove the 2 roof drip side finish moulding clips.
