Home › ENGINE ยท 2UZ-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FAN AND GENERATOR V BELT


    A122920
  1. Check the belt for wear, cracks or other signs of damage.
    If any of the following defects is found, replace the fan and generator V belt.

    1. The belt is cracked.
    1. The belt is worn out to the extent that the cords are exposed.
    1. The belt has chunks missing from the ribs.



    A141644E02
  1. Check that the belt fits properly in the ribbed grooves.

    HINT:
    Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



2. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY


    A160764
  1. Check that the belt tensioner moves downward when the belt is pressed down at the point indicated in the illustration with approximately 98 N (10 kgf, 22.0 lbf) of force.



    A141645E01
  1. Check that the arrow on the belt tensioner is within area "A".
    If it is outside area "A", replace the fan and generator V belt.

    HINT:
    When a new belt is installed, the arrow should be within area "B". If not, the fan and generator V belt is not installed correctly.