Home › ENGINE ยท 3UR-FE › ENGINE MECHANICAL › FRONT ENGINE MOUNTING

FRONT ENGINE MOUNTING > INSTALLATION

for Preparation Click here



1. INSTALL FRONT ENGINE MOUNTING INSULATOR LH


    A163787
  1. Install the mounting insulator with the nut.

    Torque:
    72 N*m{ 734 kgf*cm , 53 ft.*lbf }



2. INSTALL WATER DRAIN COCK SUB-ASSEMBLY


    A123319E01
  1. Apply seal packing to 2 or 3 threads of the drain cock.

    Seal packing:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A163782E01
  1. Install the drain cock to the cylinder block LH side.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

  1. Further tighten the drain cock within 360° so that the drain cock pipe is within the range shown in the illustration.

    NOTICE:
    1. Do not rotate the drain cock more than 1 revolution (360°) after tightening the drain cock to the specified torque.
    2. Do not loosen the drain cock to adjust it. If an adjustment is necessary, remove the drain cock and reinstall it.



3. INSTALL FRONT ENGINE MOUNTING INSULATOR RH


    A163786
  1. Install the mounting insulator with the nut.

    Torque:
    72 N*m{ 734 kgf*cm , 53 ft.*lbf }



4. INSTALL ENGINE ASSEMBLY
  1. Install the engine assembly to the vehicle (Click here).