Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > DRL Relay Circuit

for Preparation Click here


DESCRIPTION

The daytime running light relay is built into the turn signal flasher.
When the daytime running light relay receives the ignition switch ON signal from the main body ECU, the turn signal flasher illuminates the turn signal light. When the daytime running light relay receives the headlight dimmer switch signal, the turn signal flasher turns off the turn signal light.

WIRING DIAGRAM


E146735E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TURN SIGNAL FLASHER - MAIN BODY ECU)
E146736E01
  1. Disconnect the J29 relay connector.

  1. Disconnect the J3 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J29-5 (DRL) - J3-8 (DRL)
    Always
    Below 1 Ω
    J29-5 (DRL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK MAIN BODY ECU
E146750E01
  1. Disconnect the J3 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J3-8 (DRL) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V



NG
REPLACE MAIN BODY ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)