Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Bus Buffer ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
BUS BUFFER ECU COMMUNICATION STOP MODE
When either condition below is met:
  1. Accessory Gateway is not displayed on "CAN Bus Check".
  2. Applies to "BUS BUFFER ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE".
  1. Bus buffer ECU branch wire or connector
  2. Bus buffer ECU

WIRING DIAGRAM


C159605E01


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTICE:
    After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (BUS BUFFER ECU BRANCH WIRE)


    C159599E01
  1. Disconnect the J59 bus buffer ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    J59-3 (CAN+) - J59-2 (CAN-)
    Ignition switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE BUS BUFFER ECU BRANCH WIRE OR CONNECTOR (CAN+, CAN-)
OK

REPLACE BUS BUFFER ECU