ENGINE IMMOBILISER SYSTEM > Diagnosis Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - DLC3) |
![]() |
Disconnect the J26 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-9 (D) - J17-7 (SIL) | Always | Below 1 Ω |
| J26-9 (D) or J17-7 (SIL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (DLC3 - BATTERY AND BODY GROUND) |
![]() |
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J17-4 (CG) - Body ground | Always | Below 1 Ω |
| J17-5 (SG) - Body ground |
| Tester Connection | Condition | Specified Condition |
| J17-16 (BAT) - Body ground | Always | 11 to 14 V |
| J17-7 (SIL) - J17-5 (SG) | Always | Pulse generation |
|
| ||||
| OK | ||
| ||