Home › BODY › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.



1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B167110
  1. Attach the 3 claws to install the bush.



    B167109
  1. Install the lumbar support adjuster with the 2 screws.

  1. Connect the lumbar support adjuster connector.



    B167105E06
  1. Attach the 6 hooks to install the seatback spring.

  1. Install the 2 springs.



2. INSTALL FRONT SEATBACK COVER WITH PAD LH
  1. Install the seatback cover with pad to the seatback frame.



    B165534E02
  1. Using hog ring pliers, install new hog rings to the seat frame.



    B165529
  1. Attach the 4 claws to install the 2 headrest supports.



    B165533
  1. Connect the seatback cover bracket to the seat frame and install the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    After the seatback trim cover is assembled, make sure the side airbag strap is not twisted.



    B165531E02
  1. Install the seatback cover wires.

  1. Using hog ring pliers, install new hog rings to the seat frame.



    B165530E02
  1. Attach the hook.



3. INSTALL FRONT SEAT HEADREST ASSEMBLY LH


4. INSTALL INNER FRONT SEAT CUSHION SHIELD LH


B166410E01
  1. Attach the 3 claws in the order shown in the illustration, and install the cushion shield.

  1. Install the screw.



5. INSTALL FRONT SEAT CUSHION SHIELD LH


B166409E01
  1. w/ Lumbar Support Adjuster:
    Connect the switch connector.

  1. Attach the 3 claws in the order shown in the illustration, and install the cushion shield.

  1. Install the 2 screws.



    B165523E03
  1. Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with new hog rings.



6. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH


B165804
  1. Attach the claw to install the reclining adjuster release handle.



7. INSTALL VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat)
  1. Install the snap ring to the vertical seat adjuster knob.



    B166938
  1. Install the vertical seat adjuster knob to the front seat.



8. INSTALL VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat)


    B165520
  1. Install the vertical adjusting handle with the 2 screws.



    B165519
  1. Attach the 2 claws to install the vertical adjusting handle cap.



9. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat (Click here).