SEAT HEATER SWITCH (for Floor Shift Type) > INSPECTION |
| 1. INSPECT SEAT HEATER SWITCH LH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (SW) - 7 (RV) | Switch OFF | 2.7 to 4.1 kΩ |
| Switch ON (Min.) | ||
| Switch ON (Max.) | 0.28 to 0.42 kΩ |
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 8 (ILL+) Battery negative (-) → 2 (ILL-) | Illuminates |
| 2. INSPECT SEAT HEATER SWITCH RH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 (SW) - 5 (RV) | Switch OFF | 2.7 to 4.1 kΩ |
| Switch ON (Min.) | ||
| Switch ON (Max.) | 0.28 to 0.42 kΩ |
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 6 (ILL+) Battery negative (-) → 1 (ILL-) | Illuminates |