Home › BODY › SEAT › SEAT HEATER SWITCH (for Column Shift Type)

SEAT HEATER SWITCH (for Column Shift Type) > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH LH


B165795E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SW) - 7 (RV)
    Switch OFF
    2.7 to 4.1 kΩ
    Switch ON (Min.)
    Switch ON (Max.)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Illuminates

    If the result is not as specified, replace the switch.



2. INSPECT SEAT HEATER SWITCH RH


B165796E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (SW) - 5 (RV)
    Switch OFF
    2.7 to 4.1 kΩ
    Switch ON (Min.)
    Switch ON (Max.)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 6 (ILL+)
    Battery negative (-) → 1 (ILL-)
    Illuminates

    If the result is not as specified, replace the switch.