SHIFT LEVER ASSEMBLY (for Column Shift Type) > DISASSEMBLY |
| 1. REMOVE COLUMN SHIFT SHIFTING BELLCRANK ASSEMBLY |
![]() |
Remove the bolt and shifting bellcrank from the column shift control shift lever retainer.
| 2. REMOVE COLUMN SHIFT LEVER COMPRESSION SPRING |
![]() |
Remove the bolt and spring from the column shift control shift lever retainer.
| 3. REMOVE SHIFT LEVER PLATE SUB-ASSEMBLY |
![]() |
Disconnect the transmission control switch connector clamp from the column shift.
Detach the wire harness clamp and cut the 5 wire guides.
![]() |
Remove the 3 bolts.
![]() |
Separate the shift lever plate from the column shift control shift lever retainer.
| 4. REMOVE COLUMN SHIFT SHIFT LOCK RELEASE LINK |
![]() |
Remove the shift lock release link and spring from the shift lever plate.
| 5. REMOVE COLUMN SHIFT SHIFT LEVER SUB-ASSEMBLY |
![]() |
Remove the shift lever and 2 lever selecting bushes from the column shift control shift lever retainer.
![]() |
Using a thin-bladed screwdriver, release the connector housing retainer.
Insert a thin-bladed screwdriver, release the locking lug of the terminal 4 (SFTD-), 5 (SFTD+) and 11 (E), and pull the terminals out from the rear.
![]() |
Detach the 2 claws and remove the control shaft tube clamp from the column shift control shift lever retainer.
| 6. REMOVE SHIFT LOCK SOLENOID |
![]() |
Detach the 2 claws and remove the shift lock solenoid bracket.
![]() |
Remove the screw, collar, 2 bushes and shift lock solenoid with No. 1 shift lock plate sub-assembly from the column shift control shift lever retainer.
![]() |
Insert a thin-bladed screwdriver, release the locking lug of the terminal 1 (SLS+) and 8 (E), and pull the terminals out from the rear.
| 7. DISCONNECT NO. 1 SHIFT LOCK PLATE SUB-ASSEMBLY |
![]() |
Using a pin-punch and hammer, tap out the spring pin and disconnect the shift lock plate from the shift lock solenoid.
| 8. REMOVE TRANSMISSION CONTROL SWITCH (S POSITION) |
![]() |
Remove the 2 screws and switch from the column shift control shift lever retainer.
![]() |
Insert a thin-bladed screwdriver, release the locking lug of the terminal 6 (IG) and 13 (S), and pull the terminals out from the rear.
| 9. REMOVE TRANSMISSION CONTROL SWITCH (P POSITION) |
![]() |
Remove the 2 screws and switch from the column shift control shift lever retainer.