Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REPAIR

for Preparation Click here



1. REPAIR VALVE SPRING SEAT

NOTICE:
Take off a cutter gradually to make the intake valve seat smooth.



    A062787E09
  1. If the seating is too high to the valve face, use 30° and 45° cutters to correct the seat.



    A075613E07
  1. Intake side:
    If the seating is too low to the valve face, use 60° and 45° cutters to correct the seat.



    A062788E07
  1. Exhaust side:
    If the seating is too low to the valve face, use 75° and 45° cutters to correct the seat.



    A075614E01
  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. After lapping the valve by hand, clean the valve and valve seat.