Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT COIL SPRING LH


C159782E01
  1. Using SST, compress the coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    1. Do not compress the coil spring more than necessary.
    2. Do not use an impact wrench. It will damage SST.



    C155966E01
  1. Install the coil spring to the shock absorber.

    HINT:
    Fit the lower end of the coil spring into the recess of the spring seat of the shock absorber.



2. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Install the 2 cushions, 2 retainers and suspension support to the piston rod.

  1. Temporarily install a new suspension support to front shock absorber nut.



  1. Position the suspension support as shown in the illustration.


    C155967E01

  1. Remove SST.

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

    HINT:
    Release the coil spring while checking the position of the suspension support.



3. TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
  1. Tighten the nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }