KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound |

| 1.READ VALUE USING TECHSTREAM (FRONT DOOR COURTESY SWITCH LH) |
Check the Data List for proper functioning of the front door courtesy light switch LH.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Front door courtesy light switch LH signal / ON or OFF | ON: Driver side door is open OFF: Driver side door is closed | - |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH) |
Check the Data List for proper functioning of the unlock warning switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch signal /ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the J18 switch connector.
Disconnect the J1 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J18-1 - J1-5 (KSW) | Always | Below 1 Ω |
| J18-2 - Body ground | Always | 10 kΩ or higher |
| J1-5 (KSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK COMBINATION METER ASSEMBLY (OPERATION) |
Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).
Check the key reminder warning system function.
|
| ||||
| OK | ||
| ||