Home › ENGINE ยท 3UR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P060A    Internal Control Module Monitoring Processor Performance

for Preparation Click here


DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is output.

DTC Code
DTC Detection Condition
Trouble Area
P060A
When either condition below is met:
  1. ECM main CPU error
  2. ECM sub CPU error
  3. Electronic throttle monitoring CPU error
ECM

MONITOR STRATEGY


Related DTCs
None
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
-
Frequency of operation
Once per driving cycle
Duration
16 seconds
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


CPU reset
Occurred

TYPICAL MALFUNCTION THRESHOLDS


When either condition below is met:
Condition 1 or 2
1. When all conditions below are met:
-
- CPU reset
1 time or more
- Learned TP - Learned APP
0.4 V or more
- Electronic throttle actuator
OFF
2. CPU reset
2 times or more

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P060A is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)