Home › ENGINE ยท 3UR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P060B    Internal Control Module A/D Processing Performance

for Preparation Click here


DESCRIPTION

This DTC is output when a communication error occurs in the ECM.

DTC Code
DTC Detection Condition
Trouble Area
P060B
ECM main CPU communication error
ECM

MONITOR STRATEGY


Related DTCs
None
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
-
Frequency of operation
Once per driving cycle
Duration
16 seconds
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs not present
None

TYPICAL MALFUNCTION THRESHOLDS


When one of conditions is met
condition 1, 2 and 3
1. Internal control module serial communication
Fail
2. AD Converter
Fail
3. Knock sensor circuit
Fail

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P060B is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)