METER / GAUGE SYSTEM > OPERATION CHECK |
| INSPECT INDICATOR/WARNING LIGHT |
Check the following indicators and warning lights.
| Indicator/Warning light | Switch Condition | Specified Condition |
| ABS warning light | Ignition switch OFF→ ON | Comes on for 3 seconds |
| SLIP indicator light | ||
| SRS warning light | Ignition switch OFF→ ON | Comes on for 6 seconds |
| CHARGE warning light | Ignition switch OFF→ ON | Illuminates when ignition switch is turned ON. Turns off when engine is started. |
| MIL |
| INSPECT SPEEDOMETER |
Using a speedometer tester, check that the speedometer reading is within the allowable range shown in the table below. Also, check for proper operation of the odometer.
| Standard Indication | Acceptable Range |
| 20 mph | 19 to 22 mph |
| 40 mph | 39 to 42.5 mph |
| 60 mph | 59.5 to 63.5 mph |
| 80 mph | 79.5 to 84 mph |
| 100 mph | 100 to 105 mph |
| 120 mph | 120 to 125.5 mph |
| Standard Indication | Acceptable Range |
| 20 km/h | 21 to 25 km/h |
| 40 km/h | 41.7 to 46.2 km/h |
| 60 km/h | 62.7 to 67.2 km/h |
| 80 km/h | 83.4 to 88.4 km/h |
| 100 km/h | 104.3 to 109.3 km/h |
| 120 km/h | 125.1 to 130.6 km/h |
| 140 km/h | 145.8 to 151.8 km/h |
| 160 km/h | 166.2 to 173.2 km/h |
| 180 km/h | 186.9 to 194.5 km/h |
| 200 km/h | 207.7 to 215.7 km/h |
Check the deflection width of the speedometer indicator.
| INSPECT TACHOMETER (w/ Tachometer) |
Connect a tune-up tachometer, and start the engine.
Compare the test results with the tachometer indicator.
| Standard indication (rpm) | Acceptable range Data in ( ) is for reference |
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000 | (5750 to 6250) |
| 7000 | 6700 to 7300 |
| INSPECT METER/GAUGE |
Connect the Techstream to the DLC3.
Perform "Active Test" (Click here).
| INSPECT WARNING/INDICATOR LIGHT |
Connect the Techstream to the DLC3.
Perform "Active Test" (Click here).
| INSPECT MULTI-INFORMATION DISPLAY (w/ Multi-information Display) |
Connect the Techstream to the DLC3.
Perform "Active Test" (Click here).