Home › BODY ELECTRICAL › LIGHTING › CARGO LIGHT SWITCH

CARGO LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CARGO LIGHT SWITCH


    E145554E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (FCTY) - 9 (FLON)
    Cargo light switch ON
    Below 1 Ω
    Cargo light switch DOOR
    Cargo light switch OFF
    10 kΩ or higher
    10 (FLMP) - 7 (E)
    Cargo light switch ON
    Below 1 Ω
    Cargo light switch DOOR
    10 kΩ or higher
    Cargo light switch OFF

    If the result is not as specified, replace the switch.

  1. Inspect the switch illumination.

    1. Connect the battery's positive (+) lead to terminal 1 (ILL+) and the negative (-) lead to terminal 4 (ILL-).

    2. Check that the door courtesy light comes on.

      OK:
      Light comes on.

      If the result is not as specified, replace the light switch.