Home › ENGINE · 1GR-FE › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



2. INSPECT OIL PRESSURE SWITCH
  1. Disconnect the oil pressure switch connector.



    E142242E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Engine ground
    Engine stopped
    Below 1 Ω
    Engine idling
    10 kΩ or higher

  1. Connect the oil pressure switch connector.



3. INSTALL V-BANK COVER


    A112983E02
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }