THEFT DETERRENT SYSTEM > SYSTEM DESCRIPTION |
| OUTLINE OF THEFT DETERRENT SYSTEM |
The theft deterrent system is designed to deter vehicle break-ins and theft. If an attempted break-in or theft is detected, the vehicle horns and security horn will sound and the hazard warning lights will flash.
The system detects an attempted break-in or theft when any of the following occurs: 1) the vehicle is forcibly entered, 2) the engine hood is forcibly opened, 3) the doors are unlocked without the use of a key, or 4) the cable from the negative (-) battery terminal is disconnected and reconnected.
If the system enters the alarm sounding state, any unlocked doors will automatically lock.
The system has 2 modes: active arming mode (refer to "ACTIVE ARMING MODE") and passive arming mode (refer to "PASSIVE ARMING MODE"). Passive arming mode can be turned on and off using the Techstream.
Each mode has 4 states: disarmed state, arming preparation state, armed state and alarm sounding state.
Disarmed state:
Arming preparation state:
Armed state:
Alarm sounding state:
| Alarm Method | Hazard Warning Light | Blinking (cycle of flasher relay) |
| Vehicle Horn | Sounding (cycle of 0.4 seconds) | |
| Security Horn | Sounding (cycle of 0.4 seconds) | |
| Headlight | Flashing | |
| Taillight | Flashing | |
| Room light | Illuminating | |
| Security Indicator | Illuminating | |
| Alarm Time | 60 +/-5 seconds | |
| FUNCTION OF MAIN COMPONENT |
| Function | Outline |
| Security indicator | Informs driver of theft deterrent system status |
| Security horn | Sounds when attempted brake-in or theft is detected |
| Taillight | Taillights illuminate if system enters alarm sounding state when system is unset |
| Hazard warning light | Hazard warning lights begin flashing when attempted break-in or theft is detected |
| Vehicle horns | Sounds when attempted break-in or theft is detected |
| Door courtesy light switch | Detects door open status (open or closed) |
| Door unlock detection switch | Detects door unlock status |
| Engine hood courtesy switch | Detects engine hood open status (open or closed) |
| Main body ECU | Detects ignition switch condition (OFF, ON, ACC or engine running) |
| Glass breakage sensor ECU* | Glass breakage sensor ECU outputs alarm request signal to main body ECU when sound of glass breaking is detected |
| SYSTEM FUNCTION |
Disarmed state:
Arming preparation state:
Arming state:
Alarm sounding state: