Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. According to the display on the Techstream, read the "Data List".

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Engine hood courtesy switch /
    ON or OFF
    ON: Engine hood is open
    OFF: Engine hood is closed
    -
    IG SW
    Ignition switch /
    ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch OFF
    -
    Glass Break Sensor Detection*
    Glass breakage sensor detection /
    ON or OFF
    ON: Glass breakage sensor ON
    OFF: Glass breakage sensor OFF
    -

    HINT:
    *: w/ Glass Breakage Sensor


ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body / (desired system) /Active Test.

  5. According to the display on the Techstream, perform the "Active Test".

    Main body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Horn
    Security horn
    ON or OFF
    -
    Security Indicator
    Security indicator
    ON or OFF
    -

    Immobiliser 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON or OFF
    -