Home › RESTRAINTS › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / (desired system) / Data List.

  5. According to the display on the Techstream, read the "Data List".

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer setting/ON or OFF
    ON: Front passenger side seat belt warning buzzer ON setting
    OFF: Front passenger side seat belt warning buzzer OFF setting
    -

    SRS Airbag: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Buckle SW
    Driver Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    UNSET/SET
    -
    Passenger Buckle SW
    Passenger Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    UNSET/SET
    -


PERFORM ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. According to the display on the Techstream, perform the "Active Test".

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp D-seat Belt
    Driver side seat belt warning light
    ON or OFF
    -
    Indicat. Lamp P-seat Belt
    Front passenger side seat belt warning light
    ON or OFF
    -