TRANSMISSION CONTROL CABLE (for Floor Shift Type) > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Insert the column shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.
![]() |
Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.
![]() |
Connect the control cable end to the shift lever.
Move the shift lever to the N position.
![]() |
Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
![]() |
Connect the control cable with a new clip and the nut.
![]() |
Connect the transmission control cable support with the nut.
| 2. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
![]() |
Check that the adjust case's spring is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the operation after the adjustment.
| 3. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from the N position to other positions, check that the lever can be shifted smoothly and accurately to each position and that the position indicator comes on in accordance with the shift lever position.
If the indicator and shift lever position do not match, carry out the following adjustment procedures.
| 4. INSTALL FRONT CONSOLE BOX |
![]() |
Install the front console box with the 6 screws and 2 clips.
| 5. INSTALL REAR CONSOLE BOX ASSEMBLY |
![]() |
Install the rear console box with the 2 screws and 4 bolts.
| 6. INSTALL CONSOLE BOX CARPET |
| 7. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY |
![]() |
except Regular Cab:
Connect the connector.
Attach the 7 clips to install the end panel.
| 8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
w/ Trailer Towing System:
Connect the connector.
Attach the 6 clips to install the console panel.
Install the clip.

| 9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Attach the 12 clips to install the console panel.
| 10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob and twist it in the direction indicated by the arrow.
| 11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
for Automatic Air Conditioning System:
Attach the 2 claws to install the sensor.
![]() |
Connect the connectors.
Attach the 4 clips and claw to install the finish panel.
Install the 2 bolts.
Install the hood lock control lever.
| 12. INSTALL COWL SIDE TRIM BOARD LH |
![]() |
Attach the 2 clips to install the cowl side trim board.
Install the clip.
| 13. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) |
![]() |
Attach the 6 claws and 3 clips to install the scuff plate.
| 14. INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Attach the 6 claws and 3 clips to install the scuff plate.