Home › BODY ELECTRICAL › LIGHTING › GLOVE BOX LIGHT

GLOVE BOX LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL GLOVE BOX LIGHT ASSEMBLY


    B161133
  1. Connect the connector.

  1. Attach the 2 claws to install the box light.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B160593
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 screws.

  1. Install the bolt.



3. INSTALL INSTRUMENT SIDE PANEL RH


    B163940
  1. Attach the 6 claws to install the side panel.



4. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH (for Regular Cab)

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Cab)

HINT:
Use the same procedures described for the LH side.